#Rocrail linux serial#

No special drivers are required for MacOS or Linux where the SPROG Nano should appear as a USB serial device. rocrail-4981-wheezy-armhf. A compiled version of rocrail with the rocpi library. RocRail (Command Station, PC, MAC, Linuxs.I will be requesting to the rocrail community to accept this contribution and include it in the usual distribution packet Just extract the content in your rocrail source code folder and compile. rpic firmware (and also the compiled file).Capturing of power consumption from ORD-2 and ORD-3 boosters.Īs usual I am releasing all the code and updating the manual:.MM accessories, MM1Fx and the special protocols MM3, MM4 and MM5 available in ddx (under demand).Segregated programing track (PT), with the possibility to run both the trains and send commands to the PT.

#Rocrail linux full#

Full support to reading and writing cvs, only on the main.The development is not completed and coming features include: There are some other eastern eggs – as the capability to generate MFX messages). Support for NMRA accessories (no extended accessories so far).Support for NMRA (long and short addresses) – 14,28 and 128 steps.The current features included in the firmware are: There are basically two modes of use: as an auxiliary command station, or as the main command station. RPIC works together the rocpi library created for rocrail. The objective was to complement the raspberry pi with the minimum pieces of HW to get a full control center. Of course, with the right HW adaptor, it could be used with other platforms, and with the right protocol, it could be also used by other pieces of SW… but for that purposes there are already many available solutions. The main difference with other solutions is that rpic is born to be used jointly with rocrail and the raspberry pi. Yes, it is yet another solution for managing model trains. Thus, and inspired by the MDRRC Digital RailRoad Control by Robert Evers ( ), I decided to develop my own ucontroller central station. In the best scenario, the rpi was capable of use ddx through an usb adaptor, consuming a considerable amount of resources in the raspberry. The main motivation to produce this firmware has been the failure in making DDX running on the rpi ( ). RPIC is basically code running on a Microchip microcontroller (currently a pic16f1825) The raspberry and PIC (RPIC) is a very basic electronic circuit to have a multiprotocol central station running in the raspberry pi. In the last weeks I have been working on a new approach to use the raspberry pi and rocrail: RPIC. Contribución: central USB para selección vía programación.